Table maintenance method

1.What should I do if I forgot to put a thermal pad?
If the heater is left on the table for a long time, leaving a white circle mark, you can wipe it with cotton moistened with camphor oil and wipe it back and forth along the white dirt mark like a circle. It should be easy to remove the mark. Try to avoid placing cups and tableware filled with hot water or hot soup directly on the dining table, so pay attention to keep the coasters or heat insulation pads away from the table.

2. For the white dirt on the glass table, just pour some oil on the white dirt and wipe it off with old stockings.

3. In order to prevent oil stains from being difficult to remove, you may wish to use a chair cover to protect your favorite chair. When it is accidentally soiled, you only need to remove the chair cover for cleaning, which is convenient and easy, and does not hurt the dining chair.

4. Since the restaurant location is usually next to the kitchen, the table is easily contaminated with oil fume. Users should diligently wipe to reduce the adhesion of dust and facilitate cleaning later.

5.What to do when the table is scratched?
The problem of scratching the table most often occurs in families with small children. Curious and active children often make “surprises” in your life. Most of the time you will always feel that it is too late. Don’t worry, you can solve the problem like this: Wooden dinettes and chairs with color can be dyed in the injured area first, and after the dye dries, then evenly polish the wax. With wooden floor repair fluids, slight scratches on tables and chairs can also be easily removed.

6.What about the color difference caused by the overturned soup?
For woven dining tables, especially leather and cloth, if the soup of the food is spilled, if it is not processed immediately, it will produce color difference or leave stains. If the soup has dried up, try the following: Wooden tables and chairs can be cleaned with hot rags, and then repaired with dye as appropriate. The leather part must be cleaned with a rag first, and then supplemented with a special dye. The cloth part is covered with warm 5% soap and warm water with a brush. Brush off the dirty parts and dry with a clean cloth.